Brick & Stone Masonry, Building Trades, Electrical Trades, HVAC

 *Safety glasses, steel toed shoes or boots, appropriate work clothes, and three-ring notebook. Brick spacing rule, brick hammer, horse hair brush, and a 3/8” tuck pointer pointing trowel.

Do not buy anything until the first day of class and you have discussed supplies with your instructor.

*Safety glasses, appropriate work clothes, safety boots with hard soles, 25’ tape measure, hammer, tool pouch, chalk box, utility knife, hard hat, and speed square. Supplies will cost approximately $250 depending on quality purchased.

Do not buy anything until the first day of class and you have discussed supplies with your instructor.

• Tape Measure- 25’
• Claw Hammer- 12-20 oz
• Wire Strippers -must strip 14 AWG and 12 AWG (romex strippers are preferred)  
• Flat head screwdriver - (you may want a larger tip and a smaller/more fine tip)
• Phillips tip screwdriver - (approximate size #2)
• Lineman's Pliers - ( 8”- 9” recommended)
• Diagonal Cutting Pliers - (8”-9” with angled head recommended) 
• Needle Nose Pliers 
• ¼’ Nut driver
• 5/16’ Nut driver
• Non-contact voltage tester - always verify the circuit is turned off before you begin work.   (Fluke, Greenlee, or Kline are recommended)
• Conduit Reamer  (½” and 3/4”  are required you may have a larger one )
• Magnetic torpedo level
• Sharpie Fine point or ultra fine point
• Carpenter’s pencil
• UGLY’s electrical Reference (very helpful not essential for class) 
• Tool pouch - you must wear the tool pouch while working 

*Safety glasses, leather shoes, two-piece uniform.  

Do not buy anything until the first day of class and you have discussed the uniforms with the instructor.  

E.P.A. Certification is needed to earn a Lewis & Clark Career Center Certificate of Completion. The cost of this test is approximately $55.